| Why there Lines on my Copies? |
|
|
|
| Why there Lines on my Copies (How to Get rid of Them!) you ever did a copy and noticed, what there lines reduce length of page? |
 |
|
This article about identification of defects of the image or lines that the Key operator (the Person responsible for the equipment). Can establish independently and lines, which require the person of repair to establish. You would not wish to spend 75.00$ to 150.00$ for the technician to leave, only to clean your glass, whether not so? No, I did not think so.
Cut glass
With the years Multipurpose Printers, (MFP’s) arrives new problems. Fax cars, Digital Copiers and MFP’s at all are one thing together. All of them have a point on them known as “Slit the Glass.” Each car which uses a cut glass as the way to see the image finally will be soiled and will cause lines on copies along with the transferred faxes. These cars do not look through the same way by which do the senior or analogue copiers. Analogue copiers use all glass with mirrors to receive the image to the Photoconductor. Digital copiers use a cut glass. It spends this small area and uses mirrors which direct it to unit CCD. Unit CCD then transforms the analogue information to the digital information. Using the Eater of the Document or the Processor the original only transfers on a cut glass. It does not become copied from a glass where you establish the original.
How to Define, whether is the Glass of the Cut the Problem.
On Copiers MFP's and Cars of the Fax you can quickly diagnose, if a cut glass - a problem.
Copiers:
At first make a copy on a glass. If there is no display of lines make a copy through the Eater of the Document or the Processor. If there are lines on a copy then more than probable, it is the Glass of the Cut problem generation. I speak more than probable because there are cases where it, probably, not truly.
Cars of the Fax and MFP’s:
At first print magazine or the function list. To print them address to your Management of Operators. If you, at do not are a line, do a copy through the Eater of the Document or the Processor. If there are lines then, your problem - a cut glass.
Digital Copiers and MFPs
This type of a glass of a cut is easy to define. Only lift the Eater of the Document and search small rectangular glass approximately for 1 inch on 12 inches. Cмотрите on it carefully. If there will be something attached on it it will cause a line. Defect of the Image will be similar, that the small pin measured a line completely through page, though I’ve, noticed bolshy even 1 inch in width. The most general substance which I have found, adhered to a glass, white darkness. It happens, because they which do not allow it to dry before to operate it through the eater. When it dries it on a glass, does not come off easily. Other problem - blots, again it because of not permissions of enough of time for it to dry up. Impatient will actually be to cost to you more time finally.
Clearing of the Glass of the Cut.
Clearing of a glass of a cut is easy, but you should pay close attention and be convinced, that you have removed all it. Remove the nail of a finger and a scratching so much, how many you can. Receive a cotton towel and sate it with alcohol. I also recommend to use an alcohol mop. They enter into the small sealed sacks and are inexpensive and easy to find. Allow soaking of a stain within a minute, and it will weaken the white. The glass cleaner does not delete it so good as alcohol. There is something about alcohol which breaks the white. Then, be run through it with lintom the free cotton towel absorbed with the glass cleaner, and then dry it to eliminate strips. Never spray a liquid on a glass because the part of it can find its way in the car.
Fax cars.
The cut glass by the fax car can be little bit heavier to reach to. The eater of the document or the processor usually are under a control panel. Lift group and light flash light on a small glass of a cut. It - approximately 1 inch on 12 inches in diameter. Use the same technics to clean it.
You Have cleaned the Cut - the Glass, but the Line Still There.
Some times a drop white really jam on a cut glass. I have a procedure which is the silly proof in detection where a stain because sometimes it is so small, that you cannot see it. First, receive a copy which has a line on it. Hold it directly and in regular intervals on a cut glass. Look carefully and vidte, whether you can follow a line to a glass. It - where a stain.
One thing about this procedure. You should check up it both ways. Turn original 180 degrees and examine it again because the image is reversed because of a lens. Now, when you have found a stain, to you, possibly, it is necessary to use solvent to receive that stain away. They can be obstinate and difficult to remove. You can try WD-40. My technicians use solvent under the name D-blackened (Coopers). D-blackened are very expensive, but they work well. If you still have a line on your copies then, you have other problem.
Appeal to Service
Name the competent person of repair to leave and look. I recommend to use the local independent company of repair. Search for them in the Yellow pages. I recommend to the Independent politician because they usually - the smaller company, and they will give you more personified service. I hate those mad telephone systems jamming in a loop, trying to call for service.
The most part of time at them also is more experience and you will not to pay for over - razdutye hourly rates of the authorised dealer or huge corporation.
Other Problems of the Line
If you followed my tests, and you have line and copying from a glass and use of the Eater of the Document then, you have other problem. I believe, that it always - good idea to have the good technician, ready to call but why spend money when it - something so simple, any could make it. Here the list of the probable reasons. A lot of the prophetic could be wrong, thus I am not going to enter too much in detail.
The possible Reasons / Lines
Laser Printers, Laser and CONDUCTED Cars of the Fax
The cartridge blackened, the Charge roller, a paper or the object attached in blocking of the scanner, transfers a roller, optics, and a crown wire. Note: you can clean them but if you, do not know that you do you, can damage something.
Jet printers and Fax cars
Printing head, cartridge Blackened, dirty optics, a paper or the object exposed in the car, blocking printing head or optics.
The copier and MFP’s
The cartridge blackened, the Charge roller, a paper or the object attached in blocking of the scanner, transfers a roller, a crown wire, and dirty optics. Note: you can clean them but if you, do not know that you do you, can damage something.
I hope, that this article has helped you to save a part of your firm earned money. Really there is no reason to spend money when you can clean only them directly! |
|
| About the Author |
|
Bill Tucker was in the equipment of office and the industry of delivery of more than 20 years and has connected articles of the several published industries which help the end user just as to the technician. http://www.tonerovernight.com Click here for bolshego quantities of the industry has connected articles, cartridges of ink and the writing goods
Article source: http://www. ArticlesTake.com/author-bill-tucker-3002.html |
|
|
|
| |
|
|
|
|
| |
|
|
| |
|
